Beta Marine Engines

daile · daile

My beta 20 which has just seen 200 hours of trouble free service, lost power going into the harbour entrance and died within a few seconds, we had been out in very rough seas sailing, the engine had been running for approximately 20 mins at 2500 rpm. the 60lt fuel tank is 1/4 full. Apon getting towed to...

egantsea · egantsea

Hi, These are of our Racor filters. We started from this filter, the one on the right. We started the engine like we have been doing each month. We start the 38hp Beta and let it idle for about 10 minutes then put it in forward at about 10,000 rpms and let it run for another 20 min. This time it ran for a few m...

Mike · Mike

Hi, I have a Beta 1505 with Prm 120 gearbox both installed in 2005 with about 750 hours on the clock. Last year I fouled a very thick mooring rope and around the same time had cause to drive her very hard astern. After that whether coincidental or not a vibration developed in the engine at low revs going fo...

Mike · Mike

My control panel was installed in 2007 and has worked fine until now. When I start up the digital hour tachometer either has no readout, a correct readout or a readout where parts of the digits are missing. Did I see somewhere on line that there were faults with these units or is there hopefully a simp...

iidolphins · iidolphins

I currently have just about 1000 hours on my 2009 Beta 25. I would like to know the recommended Beta Marine procedure to chemically clean the Heat Exchanger Stack. Should I use a Muriatic Acid mixture for several minutes and then neutralize and rinse with baking soda? Also, what is the recommended...

Topic		Started By	Replies	Views	Last Post
	Beta 20 Running Problems (Preview) My beta 20 which has just seen 200 hours of trouble free service, lost power going into the harbour entrance and died within a few seconds, we had been out in very rough seas sailing, the engine had been running for approximately 20 mins at 2500 rpm. the 60lt fuel tank is 1/4 full. Apon getting towed to...	daile	1	846	Oct 1, 2013 by Stanley
	Water in fuel? (Preview) Hi, These are of our Racor filters. We started from this filter, the one on the right. We started the engine like we have been doing each month. We start the 38hp Beta and let it idle for about 10 minutes then put it in forward at about 10,000 rpms and let it run for another 20 min. This time it ran for a few m...	egantsea	3	886	Sep 27, 2013 by Stanley
	Bad thumping noise BV1505 (Preview) Hi, I have a Beta 1505 with Prm 120 gearbox both installed in 2005 with about 750 hours on the clock. Last year I fouled a very thick mooring rope and around the same time had cause to drive her very hard astern. After that whether coincidental or not a vibration developed in the engine at low revs going fo...	Mike	16	5167	Sep 24, 2013 by Mike
	Control Panel ABV. (Preview) My control panel was installed in 2007 and has worked fine until now. When I start up the digital hour tachometer either has no readout, a correct readout or a readout where parts of the digits are missing. Did I see somewhere on line that there were faults with these units or is there hopefully a simp...	Mike	1	1963	Sep 24, 2013 by Stanley
	Beta 25 - Recommended Heat Exchanger Stack Cleaning (Preview) I currently have just about 1000 hours on my 2009 Beta 25. I would like to know the recommended Beta Marine procedure to chemically clean the Heat Exchanger Stack. Should I use a Muriatic Acid mixture for several minutes and then neutralize and rinse with baking soda? Also, what is the recommended...	iidolphins	1	1239	Sep 4, 2013 by Stanley
«First < 1 … 76 77 78 79 80 … 147 > Last» \| Page of 147 sorted by