|
overheating query
(Preview)
Hello Again in Arapahoe-- Sometimes my 20 hp 3cylinder overheats. It has a new heat exchanger (2010). New impellor from your stock same date. I run 50/50 premixed antifreeze full strength out of the plastic jug. When this is kept topped off, no problems. However, it gets low every once in a whil...
|
pthorn
|
2
|
879
|
|
|
|
|
Replacing Yanmar 2GM with BD722 questions
(Preview)
I am considering replacing my 25 year old Yanamr 2GM, with a new Beta BD722. My boat is a 30' Seafarer, (book disp. 8600lbs, crane said 10,000 bs loaded) A couple of questions: 1. Can the beta be ordered to fit the existing 2GM mount dimensions. I see the width is similar, but iz think the BD722 mounts ar...
|
Northeaster
|
7
|
7091
|
|
|
|
|
Beta 43 married to a Volvo saildrive
(Preview)
Have you married a Beta 43 to a Volvo saildrive before? I have a friend who considering the exchange his existing Volvo 43T, for a Beta 43, but wants to use the existing saildrive. Is this economically feasible?
|
Jenain
|
2
|
585
|
|
|
|
|
Storage of engine
(Preview)
I just bought a used Beta 20 with 170 hours on it. I am building a new sailboat and won't install the engine for two to three years. I was going to change the oil and coolant then run it for ten minutes or so, drain the fuel, before storing it indoors. Is there anything else I should do?
|
Scott
|
1
|
524
|
|
|
|
|
exhaust problems
(Preview)
Hey Farron, Keith here, s/v Saga (the Allied Seawind 30' ketch). My exhaust system snapped at a weld a few inches aft of where it exits the engine (BD722). I removed it, had it welded, and re-installed it, but was still worried about it. I am in Wrightsville Beach, so I called Josh from Specialized Mar...
|
cruise
|
2
|
896
|
|
|
